Skip to content
Calls answered 24/7Office Mon–Fri 8am–5pm
6717 4th Ave, Brooklyn, NY 11220718-439-1224
Commercial Laundry SolutionsNew York · Since 2001

Error code library

Ipso error codes

Older Ipso washer-extractors with Micro9 and Micro20 controllers show short codes such as E4 or Not 2. These machines are still common in New York laundromats and laundry rooms.

Covers: Ipso washer-extractors with Micro9 and Micro20 controls, including frequency-drive models.
Based on: Ipso Micro9 and Micro20 error code lists.

Micro9 / Micro20 codes

Door locked before start

The door is already locked before the cycle started.

  • Technician: check the door lock and its switch.

Memory (EPROM) problem

Possible EPROM or EEPROM problem in the controller.

  • Technician: reprogram or replace the controller.

Vend pricing error

Probably a vend price programming error.

  • Re-check the vend price settings.

Fill time exceeded

The programmed water level was not reached in time (5 minutes on Micro9, 15 minutes on Micro20).

  • Make sure water is on, clean inlet screens, check that the drain is closed.

Heat time exceeded (Micro20)

The programmed temperature was not reached in 80 minutes.

  • Technician: check the heating system and temperature sensor.

Door lock released during operation

The door lock let go while the machine was running.

  • Technician: check the lock, switch and wiring.

Did not drain / no extract

Water did not drain, so extract could not start.

  • Clear the drain valve and drain line.

Temperature sensor (Micro20)

Temperature sensor problem.

  • Technician: test the sensor.

Motor overload tripped

The motor overload protector tripped (five times on Micro9).

  • Technician: check for drag on the basket, bearings and the motor.

Tilt (balance) switch

EA: the tilt switch tripped several times during the program. Eb: the tilt switch is out of its bracket slot or broken.

  • Redistribute the load.
  • Technician: reseat or replace the tilt switch.

No power to the motor

Possible causes: motor overload tripped, controller, 16 A fuse, motor board or communication cable.

  • Technician: work through power, fuse, motor board and cable.

No speed / tach signal

No output from the tach generator, or speed does not match the program (frequency-drive models).

  • Technician: check the tach generator and wiring.

10,000 cycle reminder

The machine has run 10,000 cycles.

  • Cancel the reminder in the vend setup procedure; a good time for full PM.

Motor board failure

The motor board is bad.

  • Technician: replace the motor board.

Water left in tub

Water is still in the tub at the end of the cycle.

  • Clear the drain.

Out of order

The Coin 2 switch was actuated and the machine was placed out of order.

  • Check the coin switch and coin path.

These explanations are general guidance written by CLS from manufacturer service documentation, and code meanings can vary by control version. Always confirm with the manual for your exact model. Disconnect power (and gas or steam) before opening any panel. Repairs inside the machine should be done by a qualified technician.

← All brands · Preventive maintenance checklists

Still showing the code?

Our factory-trained technicians service Ipso equipment across New York every day. Calls answered 24/7.